Cisco Nexus 9232E-B1 Hardware Installation Manual page 48

Fan Module LEDs
LED
(SYNC)
Link
(per-port)
M a n a g e m e n t
Port
Activity
M a n a g e m e n t
Port
Link
Fan Module LEDs
The fan module LED is located below the air holes on the front of the module.
LED
STS
Power Supply LEDs
The power supply LEDs are located on the left right portion of the power supply. Combinations of states
indicated by the Okay and Fault LEDs indicate the status for the module as shown in the following table.
Cisco Nexus 9232E-B1 NX-OS Mode Switch Hardware Installation Guide
42
Color Status
The frequency, time and phase are synchronized to an external interface. The external
Green
interface could be;
• BITS
• GPS
Recovered RX Clock
Amber The system is running in holdover/free-run mode and it is not synchronized to an external
interface as expected based on user configuration.
Off The centralized frequency/time and phase distribution is not enabled. Therefore all clocking
is based on the local oscillator on the RSP.
Off The RP/RSP is in the Standby state.
Green The port is active.
Amber The port is disabled by the operator or is not initializing.
Flashing amber The port is faulty and disabled.
Off The port is not active or the link is not connected.
Green The ethernet link is up and operational.
Off The ethernet link is down.
The port is either receiving or transmitting packets.
Yellow
Off No packets are being received or transmitted.
Color Status
Green The fan module is operational.
Red The fan module is not operational (fan is probably not functional).
Off Fan module is not receiving power.
LEDs