Appendix - Cisco Nexus 9232E-B1 Hardware Installation Manual

LEDs
• Switch Chassis LEDs, on page 41
• Fan Module LEDs, on page 42
• Power Supply LEDs, on page 42
Switch Chassis LEDs
The ATTN, GPS, STS, and Sync, LEDs are located on the left side of the front of the switch. The port LEDs
appear as triangles pointing up or down to the nearest port.
LED
ATTN
STS
GPS
Color Status
Flashing blue The operator has activated this LED to identify the piece of hardware where the LED is
located. This could be a chassis, line card, fabric card, fan tray, or power supply.
Off This switch is not being identified.
Green The switch is operational.
Amber The switch is booting up.
Red Upgrade in progress, do not remove.
Flashing red RP/RSP: A major alarm exists.
Other: Unused.
Flashing amber RP/RSP: A minor alarm exists.
Other: The device has failed.
Off Board is not enabled.
Green The GPS interface is provisioned and frequency, time of day and phase inputs are all
operating correctly.
Off The GPS interface is not provisioned, or the GPS inputs are not working correctly.
Cisco Nexus 9232E-B1 NX-OS Mode Switch Hardware Installation Guide
C
A P P E N D I X
41