Uniden EXA2245 Owner's Manual page 15

5) Connect the telephone line cord to the TEL
LINE jack and a telephone outlet once the
handset is fully charged.
If your telephone outlet isn't
modular, contact your telephone
company for assistance.
D. Choose the dial mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However some phone systems still use pulse dialing such as in rural areas.
The default setting is tone dialing. Depending on your dialing system, set the
mode as follows:
1) Press and hold flash until you hear a confirmation tone.
2) To set the dial mode for pulse dialing, press #.
Or to set the dial mode for tone dialing, press
You hear a confirmation tone to indicate the setting is complete.
• If you are not sure of your dialing system, set for tone dialing. Make a trial
call. If the call connects, leave the setting as is, otherwise set for pulse
dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones
for certain situations during a call, you may "switch-over" to tone dialing.
(Refer to "Tone Dialing Switch-over" on page 17.)
Modular
/tone.
*
Make sure your battery
pack is fully charged
before choosing the dial
mode.
G E T T I N G S T A R T E D [ 13 ]