Mounting The Base Unit On A Wall - Uniden DXAI3288-2 Series Owner's Manual

Mounting the Base Unit on a Wall

Setting the handset retainer clip for wall mounting
1) On the base unit, pull the handset retainer clip out of the
slot and rotate it clockwise 180 degrees.
2) Flip the retainer clip from front to back. Slide it back
into the slot so that the lip of the retainer is up and
the M is down. The retainer holds the handset in place.
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1) Plug the AC adapter to the DC IN 9V jack.
2) Wrap the AC adapter cord inside the molded wiring
channel as shown.
3) Plug the AC adapter into a standard 120V AC wall outlet.
4) Plug the telephone line cord into the TEL LINE jack.
Wrap the cord inside the molded wiring channel as shown.
5) Plug the telephone line cord into the telephone outlet.
6) Raise the antenna to a vertical position.
7) Align the mounting slots on the base with the mounting
posts on the wall. Then push in and down until the phone
is firmly seated.
www.uniden.com
Flip the hook tab
over so the tab
holds the handset.
DO NOT use an AC
outlet controlled
by a wall switch.
G E T T I N G S T A R T E D [ 13 ]