Table of Contents
Advertisement
MonitorLink
(Figure 14)
1. Connect
a MonitorLink/DV1
cable from the TV side
panel to the Mitsubishi
HD Receiver/Controller
back
panel.
2.
.
Connect
the MonitorLink
Control/RS-232
cable from
the TV side panel to the Mitsubishi
HD Receiver/
Controller
back panel.
Connect
the L (left) and R (right) audio cables from
the HDTV
receiver to AUDIO
LEFT and AUDIO
RIGHT
on the MonitorLink
section of the TV side
panel.
NOTE:
The 29-pin MonitorLink/DVI
and 9-pin
RS-232 cables can be found at your local electronics
store. Please refer to www.mitsubishi-tv.com
for more
information
on RS-232C
control.
r0
o.
arl
TV side panel - right
iI
[]
CAUTION:
To assure
continued
FCC compliance,
the user must
use a shidded
video interface
cable
with bonded
ferrite
cores at each end, when
using the
MonitorLink/DVI
input.
[]
MRsubishtHDS000recelver/controllerbackpa_el
Figure l4. Connecting MonitorLink
Figure 15. Connecting Computer
PC Image and Audio Connection
(Figure 15)
• Your Mitsubishi
display supports VGA, SVGA, XGA,
and WXGA PC resolutions only. (60Hz only)
1. Connect
a Mini D-sub 15-pin (RGB) cable from
the TV side panel to PC or Macintosh * back panel.
2. Connect
a PC Audio Cable (or 1/8" stereo
mini jack cable) from the TV side panel to PC or
Macintosh
back panel.
NOTE:
The Mini D-sub
15-pin (RGB) and 1/8"
(3.Smm) stereo mini jack cables can be found at your
local electronics
store.
NOTE:
Connecting
your computer
to this TV
will allow you to display your computer's
images.
Since this monitor
is widescreen
(16:9 aspect ratio),
the display configuration
will vary depending
on
which video card or driver(s) you use. You may also
need to use a Macintosh
adapter when connecting
to
some Macintosh
computers.
21
Advertisement
Table of Contents
