Mitsubishi Electric LT-2220 Owner's Manual page 14

Connecting an Antenna or Wall Outlet Cable
VHF Antenna UHF Antenna
(Channels 2q3) {Channels ] 4_69) TV side panel - right
_/ _ MH*'----
FlatTwinLead
F_atTwinLead
Externa_
Antenna
or Cable
300 Ohm to
75 Ohm
__ __ Combiner
Back Side
[]
Figure l. Connecting separate UHF and VHF
antennas.
Separate UHF and VHF Antennas
(Figure 1)
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT on the TV side
panel.
UHF/VHF combiners are not provided with
the TV. They are available at most electronic stores.
Note: This TV will only be able to provide an analog
signal through ANT on the TV side panel.
Note: Seepage 5for Outdoor Antenna Grounding
TV side panel - right
3OOOhm Flat 75 Ohm
Twin Lead Coaxial Cable
°-
optional
300 Ohm to 75 Ohm
Matching Transformer
Figure2. Connecting twin lead antenna, coaxial lead
antenna, or wall outlet cable.
Note: Seepage 5for Outdoor Antenna Grounding
Twin Lead Antenna, Coaxial Lead
Antenna, or Wall Outlet Cable
(Figure 2)
For antenna with twin flat leads:
1. Connect the 300ohm twin leads to the transformer.
2. Push the 75ohm side of the transformer onto
ANT on the TV side panel.
300ohm to 75ohm matching transformers are notprovided
with the TV. They are available at most electronic stores.
For cable or antenna with coaxial lead:
3. Connect the incoming cable to ANT on the TV
side panel.
Note: This TV will only be able to provide an analog
signal through ANT on the TV side panel.
14