Hitachi RC-BGH1FA0G Manual page 19

Once Timer (On/Off Timer) Operation
OK
To cancel Reservation
Point the signal window of the remote controller towards the indoor unit and press
●
and "On or Off set time" goes out with a beep and the (Timer) lamp on the indoor unit turns off.
NOTE
The timer may be used in three ways: Off-timer, On-timer and On/Off (Off/On)-timer. Set the current time first
●
because it serves as a reference.
On Timer and Off Timer can be set simultaneously.
●
If Weekly Timer already set, by setting the Once timer, Once timer operation is prioritized. When Once Timer operation is
●
complete, Weekly Timer operation will be activated.
On timer, Off timer or On/Off timer will get cancel if My Mode, LeaveHome key pressed.
●
During Once Timer Setting, if you do not press Time Up/Down key within 1 minute then it will come out of Timer setting
●
mode.
When both timer set simultaneously then
●
If Once timer is set then Clock setting can not be changed. If Clock button press during Once timer set, it will display set
●
Day and Month for about 10 seconds.
Off Timer
The device can be set to turn off at a preset time.
1. Press (Off-Timer) button.
2. Set the "turn-off time" with
1
3. After setting, direct the remote controller towards the indoor and press
(Send) button.
and "set time" lights up instead of blinking.
A beep sound emitted from indoor unit and the (Timer) lamp on the
indoor unit lights up.
On Timer
The device will turn on at a designated time.
1. Press (On-Timer) button.
2. Set the "turn-on time" with
3. After setting, direct the remote controller towards the indoor and press
(Send) button.
and "set time" light up instead of blinking.
A beep sound emitted from indoor unit and the (Timer) lamp on the indoor
unit lights up.
On/Off Timer
The device will turn on (off) and off (on) at the designated time.
●
The switching occurs fi rst at the preset time that comes earlier.
●
The arrow mark appears on the display to indicate the sequence of switching
●
operations.
1. Press (Off-Timer) button so that
display.
2. Set the "turn-off" time with
controller towards the indoor and press
3. Press (On-Timer) button so that
The and blink.
4. Set the "turn-on" time with
5. After setting, direct the remote controller towards the indoor and press
(Send) button
and set "turn-on" time light up instead of blinking.
A beep sound emitted from indoor unit and the (Timer) lamp on the indoor
unit lights up.
or on LCD appear with Timer which will going to execute/expire first.
- 19 -
and blink on the display.
(Time) button.
and blink on the display.
(Time) button.
and blink on the
(Time) button. After setting, direct the remote
(Send) button.
and set "turn-off" time light up.
(Time) button.
(Cancel) button.