Advertisement
• When shipping the unit, the original shipping carton
and packing materials come in handy. For maximum
protection, repack the unit as it was originally packed
at the factory.
• Do not use volatile liquids, such as insect spray, near
the unit. Do not leave rubber or plastic products in
contact the unit for prolonged period. They will leave
marks on the finish.
• The top and rear panels of the unit may become
warm after a long period of use. This is not a
malfunction.
• When the unit is not in use, be sure to remove any
discs and turn off the power.
• The unit may not function properly if you do not use it
for a long period of time. It is recommended that you
turn the unit on occasionally to prevent potential
problems in operation.
• Place the unit on a level surface.
Do not use it on a
shaky or unstable
surface such as a wobbling
table or
inclined stand. The loaded disc may become dis-
aligned
and damage
the unit.
• When you place this unit near a TV, radio, or VCR,
the playback
picture may become
poor and the sound
may be distorted.
In this case, place the unit away
from the TV, radio, or VCR.
Moisture condensation damages the unit. Please
read the following
carefully.
Moisture
condensation
occurs,
for example,
when you
pour a cold drink into a glass on a warm day. Drops of
water form on the outside
of the glass.
In the same way,
moisture
may condense
on the optical
pick-up
lens
inside this unit, one of the most crucial internal parts of
the unit.
Moisture condensation may occur in the
following
cases.
• When you bring the unit directly from a cold place to
a warm place.
• When you use the unit in a room where you just
turned on the heater, or a place where the cold wind
from the air conditioner
directly hits the unit.
•
In summer,
when you use the unit in a hot and humid
place just after you move the unit from an air
conditioned
room.
• When you use the unit in a humid place.
=C
O
Use a soft, dry cloth for cleaning.
• Do not use any type of solvent, such as thinner
and
benzine,
as they may damage
the surface of the unit.
• If you use a chemical
saturated
cloth to clean the unit,
follow that product's
instructions.
• Do not use the unit when moisture condensation
may occur.
If you use the unit in such a situation,
it may damage
discs and internal parts. Remove
the disc, connect
the power cord of the unit to the wall outlet, turn on
the unit, and leave it for two or three hours. After two
or three hours, the unit will have warmed
up and
evaporated
any moisture.
Keep the unit connected
to
the wall outlet and moisture
condensation
will seldom
occur.
Wall outlet
Advertisement
