1. Manuals
  2. Brands
  3. Mishimoto Manuals
  4. Automobile Accessories
  5. MMHE-G80-21
  6. Installation manual

Mishimoto MMHE-G80-21 Installation Manual

Heat exchanger fits 2021+ bmw g8x m3/m4
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

INSTALLATION GUIDE
HEAT EXCHANGER FITS 2021+ BMW G8X M3/M4
TABLE OF CONTENTS
Pg 1
RESOURCES AND CONTACT INFORMATION
Pg 2
Pg 6
MISHIMOTO
7 BOULDEN CIRCLE, NEW CA STLE, DE 19720
SKU: MMHE-G80-21
RESOURCES & CONTACT
CALL 1-877-GOMISHI
CUSTOMER SERVICE HOURS: MON–FRI 8:30AM–5:00PM EST
MISHIMOTO
GOMISHIMOTO
MISHIMOTO
WEBSITE
WWW.MISHIMOTO.COM
ENGINEERING BLOG
WWW.MISHIMOTO.COM/ENGINEERING
P
1.877.GOMISHI
W W W.MISHIMOTO.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MMHE-G80-21 and is the answer not in the manual?

Questions and answers

Related Manuals for Mishimoto MMHE-G80-21

Summary of Contents for Mishimoto MMHE-G80-21

  • Page 1 INSTALLATION GUIDE HEAT EXCHANGER FITS 2021+ BMW G8X M3/M4 SKU: MMHE-G80-21 TABLE OF CONTENTS RESOURCES & CONTACT Pg 1 CALL 1-877-GOMISHI RESOURCES AND CONTACT INFORMATION CUSTOMER SERVICE HOURS: MON–FRI 8:30AM–5:00PM EST IMPORTANT SAFETY INFORMATION Pg 2 MISHIMOTO REQUIRED TOOLS INSTALLATION INSTRUCTIONS...
  • Page 2 Remove the auxiliary cooling system reservoir cap to allow for easy draining of the system. DISCLAIMERS › This instruction manual is focused on installing a Mishimoto part and may not comprehensively cover removal and reinstallation of factory components › Raise vehicle only on jack stands or a vehicle lift. Never use only a jack.
  • Page 3 Once complete, remove the hood latch cable from the tabs and remove the upper radiator bracket from the vehicle. Continued on next page Installation Guide | SKU: MMHE-G80-21 | 2021+ BMW G8X M3/M4 HEAT EXCHANGER...
  • Page 4 It may be necessary to use a pick tool to release this tab to fully remove the cover. Install the Mishimoto heat exchanger into the vehicle. It may be helpful to rotate the heat exchanger clockwise (facing the front of the...
  • Page 5 Vacuum fill the secondary cooling system with factory HT-12 screws and a 2mm hex key. We suggest putting a small amount of coolant or Mishimoto liquid chill. Make sure to check for any leaks threadlocker on the set screws to prevent them from backing out.
  • Page 6 Mishimoto will place the customer on is being submitted. backorder and ship the replacement product to the purchaser once it becomes available.

Table of Contents