Helpful Hints - Uniden BC350A User Manual

General Use
Turn the scanner off before disconnecting the power.
Always write down the programmed frequencies in the event of
memory loss. If memory is lost, simply reprogram each channel.
The display shows "MEMO LOSS" when memory is lost.
Always press each keypad button firmly until you hear the entry
tone for that key entry.
Location
If strong interference or electrical noise is received, relocate the
scanner or its antenna away from the source of the noise. A
higher elevation, if possible, may provide better reception. You
might also try changing the height or angle of the telescoping an-
tenna.
Do not use the scanner in high-moisture environments such as the
kitchen or bathroom.
Avoid placing the unit in direct sunlight or near heating elements or
vents.
Do not plug the scanner into an outlet controlled by a wall switch
as prolonged periods without power will cause scanner memory
loss.
Cleaning
Disconnect the power to the unit before cleaning.
Clean the outside of the scanner with a mild detergent.
To prevent scratches, do not use abrasive cleaners or solvents.
Be careful not to rub the LCD window.
Do not use excessive amounts of water.
Repairs
Do not attempt any repair. The scanner contains no serviceable
parts. Contact the Uniden Customer Service Center or take it to a
qualified repair technician.
Birdies
All radios are subject to receiving undesired signals or birdies. If your
scanner stops during SEARCH mode and no sound is heard, it may be re-
ceiving a birdie. Birdies are internally-generated signals inherent in the
electronics of the receiver. If the interference is not severe, you might be
able to turn [SQ] counterclockwise to cut out the birdie. Or, press
[SEARCH] to resume searching. (Known birdie frequencies for the
BC350A are: 31.200, 41.600, and 52.000 MHz)

Helpful Hints

21