Subscribe to Our Youtube Channel
Related Manuals for Lumberjack CBS45LS
Summary of Contents for Lumberjack CBS45LS
- Page 1 MINI TOOL SHARPENER CBS45LS CAUTION: FOR YOUR OWN SAFETY; Read and follow all of the Safety and Operating Instructions before operating this sharpener. Owner’s Manual...
-
Page 2: General Safety Instructions
SAFETY INSTRUCTIONS GENERAL SAFETY INSTRUCTIONS Operating this Sharpener can be dangerous if safety and common sense are ignored. The operator must be familiar with the operation of the tool. Read this manual to understand this Sharpener. DO NOT operate this Sharpener if you do not fully understand the limitations of this tool. - Page 3 SAFETY INSTRUCTIONS ALWAYS WEAR EYE PROTECTION. Any power tool can throw debris into the eyes during operations, which could cause severe and permanent eye damage. Everyday eyeglasses are NOT safety glasses. 11. ALWAYS WEAR HEARING PROTECTION. Plain cotton is not an acceptable protective device.
- Page 4 KNOW YOUR SHARPENER ADJUSTABLE MULTI-POSITION REAR TOOL REST LOCK KNOBS ADJUSTABLE FRONT TOOL REST REVERSE-OFF-FORWARD CONTROL SWITCH The Sharpener is designed with numerous features to quickly and safely sharpen various items around the house and workshop. A fine grit grinding wheel is used to produce a sharp and precise cutting edge.
- Page 5 KNOW YOUR SHARPENER Sharpening is an easy operation to perform as long as the following items are followed: CLEAN the item to be sharpened prior to beginning any sharpening operations. ALWAYS use the factory bevel (cutting edge angle) as a guide to sharpening the tool.
- Page 6 OPERATING THE SHARPENER The Sharpener is designed for sharpening knives, scissors, flat chisels, and more. ALWAYS WEAR EYE PROTECTION! Hot sparks may be produced during sharpening operations. The electrical power switch must be in the OFF position. The power cord must be unplugged from the electrical receptacle. Place the Sharpener on flat, firm, and water-resistant surface.
- Page 7 OPERATING THE SHARPENER 12. If the item to be sharpened is in good condition, then proceed to lay the item flat on either of the tool rests as shown in Fig. D. Loosen the lock knobs and adjust the tool rest until the original bevel angle of the item to be sharpened is matched. Maintain a 1/8”...
-
Page 8: Maintenance
Machine not plugged in Plug power cord into electrical receptacle not run Power switch in “OFF” position Push switch to Forward or Reverse Return to Lumberjack Service Center Power cord is faulty Fuse or circuit breaker are open Overloaded electrical circuit Damaged motor...
Need help?
Do you have a question about the CBS45LS and is the answer not in the manual?
Questions and answers