6.3
Engine peripherals and drivetrain
ⓘ
You can find general information on the drivetrain
of the eSprinter in chapter 3.3 Selecting the basic
vehicle (→ page 20).
DC/DC converter and body manufacturer interface
⑴ NOTE
Attachments to the DC/DC converter by the Upfitter
are not permissible.
The terminal strip (code EK1) is available for connect-
ing aftermarket electrical consumers, see chapter 8.4
Interfaces and electric lines (→ page 44).
Modifications to the vehicle
⑴ NOTE
All specifications and restrictions regarding vehicle
modifications in the present Body-Equipment-Guide-
line for the eSprinter must be observed, in particular
in chapter 1.4 Operational safety (→ page 6).
⑴ NOTE
If work is carried out on a vehicle with an electric
drive, the country-specific specifications regarding
statutory protective equipment and the accident
prevention regulations must be observed.
Mercedes-Benz | Supplemental Guideline for eSprinter – Model Series 907, Edition 2023-8
6 Modifications to the basic vehicle
6.3.1
Fuel system
A fuel system is not present in a purely electrically
powered vehicle by design.
6.3.2
Exhaust gas aftertreatment system
An exhaust gas aftertreatment system is not present on
a purely electrically powered vehicle by design.
6.3.3
Exhaust system
An exhaust system is not present on a purely electri-
cally powered vehicle by design.
6.3.4
Engine cooling
⑴ NOTE
The value of the free cooling air inlet area of
14.8 dm
2
must not be changed.
37