Troubleshooting Guide - XPower A-2B Owner's Manual

Troubleshooting Guide

PROBLEM
Cyber Duster
does not start
Battery can't
be charged
Unit runs but
the speed
/ noise is
abnormal
Abnormal
Temperature
of the airflow
or housing
Nozzle falls off The nozzle is not properly
English - 12
POSSIBLE CAUSE
No electricity.
The power cord is not properly
plugged in.
Battery is not activated yet.
Low battery capacity.
Charger malfunctions or battery is
permanently damaged.
Air inlet or air outlet is blocked.
Low battery capacity.
This product uses a high RPM
motor to provide powerful airflow
and could create a certain level of
noise. This is a normal sound.
This product generates powerful
motor heated air. After a
prolonged use, the airflow and
the machine surface might reach
a high temperature.
installed.
SOLUTION
Check for power supply.
Remove and reconnect the power
cord.
Please charge the battery until full
prior to initial use.(See Page 8:
Charge the Battery)
When the battery capacity is 20%
or lower, in order to protect the
battery, the preset program will
stop the machine and prohibit the
machine from working again.
Page 8: Charge the
Contact XPOWER for additional
assistance.
Remove blockage and clean the
filter or nozzle attachment.
(See Page 8: Charge the
Use a wider opening nozzle
attachment, switch to the lower
speed setting or operate in a
outdoor place.
Stop using for at least one hour
until fully cooled down. Clean the
filter and check if the air inlet or
outlet is blocked. Use a glove the
isolate the heat coming from the
housing.
Follow the installation guide.
Secure the nozzle before use.
(See
Battery)
Battery)