Rheem 953060DP Owner's Manual And Installation Instructions page 14

ABOUT YOUR WATER HEATER
Do not use aerosols, stain removers and chemicals near the water heater
whilst it is working. Gases from some aerosol sprays, stain removers and
chemicals are corrosive to the materials used in the heat pump system.
Do not store swimming pool chemicals, household or industrial cleaners, etc.,
near the water heater.
Ensure the air inlet and outlet louvres and air flow are not obstructed in any
way at any time.
TO TURN OFF THE WATER HEATER
•
Switch off the electrical supply at the isolating switch to the water heater.
•
Close the isolation valves at the inlet and outlet of the water heater.
TO TURN ON THE WATER HEATER
•
First, ensure the water is connected to storage tanks, the system is filled with
water and all valves between the tanks and the water heater are open.
•
Switch on the electrical supply at the isolating switch to the water heater.
Note: The water heater may not turn on immediately when it is first switched on,
if it is switched on within 20 minutes to 2 hours of it having been switched off at
the isolating switch, or the heat pump has just completed a heating cycle. The
water heater will wait until the conditions for start-up are favourable in order to
protect the compressor from damage. This may take up to 20 minutes to 2 hours.
VICTORIAN CUSTOMERS
Notice to Victorian Customers from the Victorian Building Authority. This water
heater must be installed by a licensed person as required by the Victorian
Building Act 1993.
Only a licensed person will give you a Compliance Certificate, showing that the
work complies with all the relevant Standards. Only a licensed person will have
insurance protecting their workmanship for 6 years. Make sure you use a
licensed person to install this water heater and ask for your Compliance
Certificate.
14