Advertisement
of the PC.
- Do not select establish the DHCP and DDNS about settings of the
network camera and PC.
For more detailed information, refer to the Operating Instructions.
8. MOUNTING
Two ways of mounting are shown in the following figures. MAC Address and Serial Number are
indicated on the bottom label of the main unit of the Network Camera. Please record both of them on the
Network Camera Memo on Operating Instruction. They are indispensable for setting network
parameters after mounting the Network Camera and for future customer servicing.
8.1. MOUNTING ON THE TABLE
Mount the Network Camera at an even place where vibrations etc. are few.
Note:
If this camera is installed in a commercial or industrial building, local building code may require specific
installation methods to be used. In such cases we strongly suggest that you contact your local building
inspector so that the installation complies with any applicable building code.
8.2. MOUNTING ON THE CEILING
Please set the Tilt range to [On the ceiling] on Camera Setup window on Operating Instruction. Two
ways of wiring can be considered; wiring through a hole made in the ceiling or wiring without making a
hole for a cable in the ceiling. Please select either one of the two.
19
Advertisement
