Table of Contents

Advertisement

Available languages

Available languages

Quick Links

IB51457622
Installation Instructions – Prevail Maxx / USSL Maxx
Instructions d'installation – Prevail Maxx / USSL Maxx
Instrucciones de instalación – Prevail Maxx / USSL Maxx
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of the
product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting
any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Refer to product label for specific minimum supply conductor requirements.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind
that may arise from the improper, careless, or negligent installation, handling or use of this product.
NOTICE: Green ground wire provided in proper location. Do not relocate.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on
delivery receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be
filed within 15 days of delivery. All damaged material, complete with original packing must be retained.
Safety: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
APPLICATIONS: This lighting fixture is designed for outdoor lighting services, and should not be used in area
of limited ventilation or inside high ambient temperature enclosures. It must be stored in a dry location prior to
installation. Do not expose lighting fixture to rain, dust or other environmental conditions prior to installation
and insertion of photo control or shorting cap (if so equipped). Best results will be obtained if installed and
maintained according to the following recommendations.
Regulatory Information: This equipment has been test and found to comply with the limits of a Class A digital
device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
WARNING
WARNING
Brand Logo
reversed out of
black
INS #
INS #

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Prevail Maxx and is the answer not in the manual?

Questions and answers

Summary of Contents for Cooper Prevail Maxx

  • Page 1 Failure to comply with these instructions may result in death, serious bodily injury and property damage. DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise from the improper, careless, or negligent installation, handling or use of this product.
  • Page 2: Installation

    Installation Instructions – Prevail Maxx / USSL Maxx INSTALLATION This lighting fixture has been shipped complete with one Split Washer of several mounting options. Please follow the installation Washer instructions specific to the catalog part that you ordered. Care must be taken not to set lighting fixture down on opti- cal lenses.
  • Page 3: Wall Mount

    Installation Instructions – Prevail Maxx / USSL Maxx Wall Mount Insert customer lead wires into fixture through grommet hole and slide fixture on to the mast arm Tools required adapter. Manage wire routing during this process. #2 Phillips head screw driver, 3/4” socket, and torque Install the (3) 1/4-20 x 1.25”...
  • Page 4 Installation Instructions – Prevail Maxx / USSL Maxx Mast Arm, Fixed (FMA) (Fig. 8) Pole Mount, Adjustable (ADJA) Tools Required Tools Required (Fig. 10) 3/16” Allen wrench, drill with 7/16” drill bit, ratchet with #2 Phillips head screw driver, torque wrench, 9/16” & 3/4”...
  • Page 5 Installation Instructions – Prevail Maxx / USSL Maxx Slipfitter, Adjustable (ADJS) (Fig. 11 and 12) Tools Required Access Cover 3X - #8 Screw 9/16” & 3/4” socket wrench, 1/4” Allen wrench, #2 Phillips Center Wire Way head screwdriver, torque wrench...
  • Page 6: Maintenance

    Installation Instructions – Prevail Maxx / USSL Maxx Slipfitter, Adjustable (SP2) (Fig. 14) Photocontrol Orientation (If Equipped – Fig 15.) Tools required If your luminaire is equipped with a photocontrol ote: receptacle, see IB525002EN Photocontrol Ratchet with 9/16” and 3/4”sockets, #2 Phillips head...
  • Page 7 Installation Instructions – Prevail Maxx / USSL Maxx House Side Shield - COB - Field Installed House Side Shield - Discrete - Field Installed Tools required Tools required #2 Phillips Driver and pliers T20 Torx Bit screw driver Carefully remove plastic push pins on optics as shown Install house side shield with existing #8 T20 Torx in (Figure 16).
  • Page 8 Le fait de ne pas se conformer aux instructions suivantes peut causer la mort ou entraîner des blessures graves ou des dommages matériels. EXONÉRATION DE RESPONSABILITÉ : Cooper Lighting Solutions n’assume aucune responsabilité pour les dommages ou pertes de quelque nature que ce soit pouvant découler d’une installation, d’une manipulation ou d’une utilisation inappropriée, imprudente ou négligente de ce produit.
  • Page 9 Instructions d’installation – Prevail Maxx / USSL Maxx INSTALLATION Ce luminaire est livré avec toutes ses pièces et l’une des Rondelle fendue différentes options de montage. Suivez les instructions Rondelle d’installation correspondant à la pièce commandée dans le catalogue. Prenez soin de ne pas déposer le luminaire sur les lentilles.
  • Page 10: Montage Mural

    Instructions d’installation – Prevail Maxx / USSL Maxx Câblage de la crosse facultative Installez le couvercle du bras et serrez les deux (2) vis à tête cruciforme à un couple de 2,3 Nm (20 po-lb). Installez la crosse selon les étapes 2 à 4.
  • Page 11 Instructions d’installation – Prevail Maxx / USSL Maxx Retirez le passe-fil sur les fils du luminaire situés à de n’endommager aucun fil à l’intérieur de la crosse. l’arrière du luminaire comme montré à la Figure 8. Une Elle peut être prépercée pour éviter d’endommager les fois retiré, le luminaire ne possède plus son indice de...
  • Page 12 Instructions d’installation – Prevail Maxx / USSL Maxx Serrez les deux boulons à embase à l’intérieur du luminaire à un couple de 54 Nm (40 pi-lb). Couvercle d’accès 3X – Vis n° 8 Faites passer les fils d’alimentation du luminaire dans Goulotte guide- la cavité...
  • Page 13: Entretien

    Instructions d’installation – Prevail Maxx / USSL Maxx Remettez le couvercle d’accès, puis serrez les trois (3) Depuis l’intérieur du bras avec adaptateur d’emboîtement, connectez les fils d’alimentation aux vis n° 8 à un couple de 14 pi-lb. fils d’alimentation du luminaire appropriés : 3X –...
  • Page 14 Instructions d’installation – Prevail Maxx / USSL Maxx Écran maison latéral - COB - installé sur place Écran maison latéral - discret - installé sur place Outils requis Outils requis Tournevis Phillips no 2 et pinces Tournevis Torx T20 Retirez soigneusement les goupilles-poussoirs en Installez l’écran maison latéral avec les vis Torx no 8 T20...
  • Page 15 El incumplimiento de estas instrucciones puede provocar la muerte, lesiones corporales graves y daños materiales. EXENCIÓN DE RESPONSABILIDAD: Cooper Lighting Solutions no asume ninguna responsabilidad por daños o pérdidas de ningún tipo que puedan surgir de la instalación, el manejo o el uso incorrectos, descuidados o negligentes de este producto.
  • Page 16: Instalación

    Instrucciones de instalación - Prevail Maxx/USSL Maxx INSTALACIÓN Este luminario se ha enviado completo, con una de varias Arandela dividida opciones de instalación. Siga las instrucciones de instalación Arandela específicas para la pieza del catálogo que solicitó. Se debe tener cuidado de no colocar el luminario sobre los lentes ópticos.
  • Page 17 Instrucciones de instalación - Prevail Maxx/USSL Maxx Cableado de accesorios opcionales del brazo del Instale la cubierta del brazo y ajuste los dos (2) tornillos de cabeza Philips a 20 in-lb (2,3 N·m). Como se mástil muestra en la (Figura 5). Instale el brazo del mástil de los pasos 2-4.
  • Page 18 Instrucciones de instalación - Prevail Maxx/USSL Maxx se suministran) en la puerta como se muestra en la Perfore un orificio de 7/16 in (1,11 cm) a través del (Figura 8). brazo del mástil e instale el tornillo de cabeza de hongo y cuello cuadrado de 3/8 in y la tuerca. Apriete a 14 Retire la arandela del cable para los cables del luminario ft-lb (19 N·m).AVISO: Tenga cuidado al perforar este...
  • Page 19 Instrucciones de instalación - Prevail Maxx/USSL Maxx Ajuste ambos tornillos de la brida dentro del luminario a 40 ft-lb (54 N·m). Cubierta de acceso 3 tornillos n.º 8 Pase los terminales del luminario a través de la abertura Canaleta para central de la placa de tuerca, el poste y el brazo, en la...
  • Page 20: Mantenimiento

    Instrucciones de instalación - Prevail Maxx/USSL Maxx Dentro del brazo del conector deslizante, conecte los cables de suministro a los terminales del luminario Cubierta de 3 tornillos acceso n.º 8 correspondientes: Canaleta para cables en el centro Adaptador El cable de conexión a tierra del lado de...
  • Page 21 Instrucciones de instalación - Prevail Maxx/USSL Maxx Pantalla lateral del alojamiento - COB - Instalada in Pantalla lateral del alojamiento - Discreta - Instalada situ in situ Herramientas necesarias Herramientas necesarias Destornillador Phillips n.º 2 y alicates Destornillador Torx T20 Retire con cuidado los pines de presión plásticos que Instale la pantalla lateral del alojamiento con los se encuentran en las ópticas como se muestra en la...
  • Page 22 Veuillez consulter le site www.cooperlighting.com/legal pour obtenir les conditions générales. Garantías y Limitación de Responsabilidad Visite www.cooperlighting.com/legal para conocer nuestros términos y condiciones. Cooper Lighting Solutions 1121 Highway 74 South Cooper Lighting Solutions is a Peachtree City, GA 30269 registered trademark. P: 770-486-4800 All trademarks are property www.cooperlighting.com...

This manual is also suitable for:

Ussl maxx

Table of Contents