Page 1
QUICK START GUIDE 2000 Series • 115 V / 60 Hz...
Page 2
U-Line Customer Care must be contacted immediately at +1.414.354.0300. Service or repairs performed on the unit without prior written approval from U-Line is not permitted. If the unit has been altered or repaired in the field without prior written approval from U-Line, claims will not be eligible.
8. Control Operation 10. First Use 10. Sabbath Mode 11. Warranty 1 year + 1 with registration This product is eligible for an additional one-year warranty at no charge when you register your product on u-line.com. See complete warranty for details.
QUICK START GUIDE QUICK START GUIDE u-line.com Safety and Warning DANGER NOTICE This unit contains R600a (Isobutane) which is a Please read all instructions before installing, flammable hydrocarbon. It is safe for regular operating, or servicing the appliance. use. Do not use sharp objects to expedite defrosting.
QUICK START GUIDE QUICK START GUIDE u-line.com Environmental Requirements Electrical This model is intended for indoor/interior applications only WARNING and is not to be used in installations that are open/ exposed to natural elements. SHOCK HAZARD — Electrical Grounding Required. Never attempt to repair or perform This unit is designed to operate between 50°F (10°C) and...
QUICK START GUIDE QUICK START GUIDE u-line.com Door Swing Wall For Integrated models that are installed adjacent to a wall, 1/2" (13 mm) 1/4" (6 mm) clearance is recommended from wall on hinge side to allow the door to open 90°. Allow for additional space for any knobs or pulls installed on the integrated panel/frame.
QUICK START GUIDE QUICK START GUIDE u-line.com Door Adjustments DOOR ALIGNMENT AND ADJUSTMENT Align and adjust the door if it is not level or is not sealing properly. If the door is not sealed, the unit may not cool T-25 Torx Screw properly, or excessive frost or condensation may form in the interior.
QUICK START GUIDE QUICK START GUIDE u-line.com 3. Using T-25 Torx bit loosen screw #1 and remove screw #2 on top and bottom hinge. Slide and remove the door from unit. Completely remove screw #1 on top and bottom. Rotate Front and Back Legs to Adjust 3.
6. Secure integrated panel to door using Clamp clamps. A robust 1. Fully open door. tape may also be used. U-Line 2. Starting at corner, pull recommends the gasket away from door. use of bar clamps Door/Drawer to secure the panel to the door.
Page 10
QUICK START GUIDE QUICK START GUIDE u-line.com 11.Remove clamps from door. NOTICE If panel requires additional adjustment after removing clamps, slightly loosen each screw and adjust panel as necessary. Tighten screws upon completion. 12.Starting at the corners, re-install the gasket into the gasket channel in the frame.
QUICK START GUIDE QUICK START GUIDE u-line.com Control Operation ALL 2200 SERIES EXCEPT ZWC Up Down Light Power Used LED CONTROL FUNCTION GUIDE FUNCTION COMMAND DISPLAY/OPTIONS ON/OFF Press and release Unit will immediately turn ON or OFF. Press and release to leave interior Toggle lights Glass door wine and beverage centers only.
Page 12
QUICK START GUIDE QUICK START GUIDE u-line.com 2200 SERIES ZWC Up Down Light Power Auxiliary LED CONTROL FUNCTION GUIDE FUNCTION COMMAND DISPLAY/OPTIONS ON/OFF Press and release Unit will immediately turn ON or OFF. Toggle lights Press and release Leave interior light on for 3 hours.
QUICK START GUIDE QUICK START GUIDE u-line.com First Use All U-Line controls are preset at the factory. Initial startup requires no adjustments. NOTICE U-Line recommends allowing the unit to run overnight before loading with product. When plugged in, the unit will begin operating under the factory default settings.
Page 14
For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase. All service provided by U-Line under the above warranty must be performed by a U-Line factory authorized servicer, unless otherwise specified by U-Line.
Need help?
Do you have a question about the U2224ZWCINT60B and is the answer not in the manual?
Questions and answers