Advertisement
m@ How to Use MONITOR
To monitor the signal from the VCR-1 deck used for playback:
<Preparations>
Perform the operations in 'Before operating' steps [1] — [3] on page 10.
[1] Press the MONITOR SELECT "SOURCE 1" button.
[2] Play back the VCR-1 deck used for playback.
To monitor the signal from the AUX jacks (CD player):
[1] Press the MONITOR
SELECT ''AUX/MIC" button so that the indicator lights.
At this time, check that the 'SOURCE
1" indicator is lit.
[2] Play back the CD player, etc. connected to the AUX jacks, At this time, check
that the microphone is not connected to the MIC jack.
To monitor the input signal from the playback VCR-1
again, press the AUX/
MIC button again or press the SOURCE 1 button.
To monitor the character generator:
<Preparations>
Play back the VCR deck used for playback,
[1] Press the MONITOR SELECT "C/G PRE-VIEW" button.
[2] Press the page button in the Character Generator control section corresponding
to the required page memory. If titles have been stored in memory, they will
be superimposed on the picture,
P4—
}
@When page indication appears (shows the create mode):
@\|f no page indication appears (shows that the
INSERT switch is ON):
Ste
CHARACTER GENERATOR
PAGE
3
DATE/SHIFT
CREATE
a
Advertisement
