Reversing The Door - U-Line Origins CO29 Installation Manual

Wall
1/4" Min.
90°
Door Swing
Right-Hand Hinge
Wall or Wall or
1"
Cabinet Cabinet
Min.
145°
Door Swing
Left-Hand Hinge –
Flush with Cabinet or Wall
Figure 3
02/2005
CO29A and CO29FF Ice Maker/Refrigerators
21-7/16"
22-3/8"
Wall or
Cabinet
9"
Min.
Door
Swing
Wall or Cabinet
Left-Hand Hinge –
Adjacent to Cabinet or Wall

Reversing the Door

All units may be left- or right-hand opening.
Note: The grille should not yet be installed. If it has been
installed, remove it for door reversing. See Page 10.
To reverse the door:
1. Remove top hinge from cabinet (three screws). See
Figure 4. Hold door to keep it from falling.
2. Lift the door off the bottom hinge.
Figure 4
3. Remove bottom hinge from cabinet (two screws). See
Figure 5. Remove screws on opposite side of cabinet
(Figure 6). Note that there may be a nut behind one or
both screws on either side.
Figure 6
4. Install hinge on opposite side, bottom of cabinet. See
Figure 7. Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
5
Figure 5
Figure 7
www.U-LineService.com