Honda HF1211 Operator's Manual page 39

EN 38
B
RAKE ADJUSTMENT
The adjustment will need to be made while
the parking brake is engaged.
For mechanical drive models:
Loosen the nut (1) which holds on the
bracket (2) and turn the nut (3) until the
length of the spring (4) is 46 - 48 mm
inside the washers. When the adjust-
ment has been made, tighten the nut
(1).
For hydrostatic drive models:
Turn the nut (5) until the length of the
spring (6) is 45 - 47 mm inside the
washers.
IMPORTANT
brake unit.
A
DJUSTING DRIVE ENGAGEMENT
For mechanical drive models:
If you should notice that forward drive power has dropped, you can adjust the
regulating screw (1) which is accessible through the hatchway beneath the
seat. Undoing the screw and then
lengthening the spring (2) will increase
the drive ability.
The best length for the spring is 86 mm
measured from the outer ends of the
spring. Once the adjustment has been
made, tighten the locknuts (3). Exces-
sive spring tension may cause too sud-
den engagement of the clutch, resulting
in the machine tipping up.
Do not screw to below these values to avoid overloading the
3 4
46 - 48
mm
1
45 - 47
1 3
MAINTENANCE
2
mm
5
6
86 mm
2