Honda HF1211 Operator's Manual page 37

EN 36
When any of these devices are activated, the machine stops.
IMPORTANT
type and ampere rating, and never one of a different rating.
If you cannot find the cause of the protection device's activation, consult your
Dealer.
C
HANGING WHEELS
Stop the machine on a flat surface and put
blocks under a load-bearing part of the frame
on the side that the wheel is to be changed.
The wheels are held by a snap ring (1) which
can be taken off with a screwdriver.
The rear wheels are directly coupled to the
axle shafts and fastened by a key that forms
part of the wheel's hub.
Before re-fitting a wheel, smear some grease
on the axle and carefully re-fit the snap ring
and washer (2).
NOTE
they are of the same diameter, and check that cutting deck is horizontal to pre-
vent an uneven cut.
C
HANGING AND REPAIRING TYRES
Tyres are of the «Tubeless» type and therefore all puncture repairs will have to be
carried out by a tyre-repair expert in accordance with the methods for this kind of
tyres.
C
HANGING BELTS
The motion from the engine to the rear axle and from the motor to the blade is
obtained by two "V" belts, whose duration largely depends on how the machine is
used.
Replacing belts is quite complicated because of dismantling and adjustments and
A blown fuse must always be replaced by one of the same
Should you substitute one or both rear wheels, ensure that
MAINTENANCE
2 1