Specifications - Cobra 19 MINI Owner's Manual

Specifications

Intro Operation Customer
General
Assistance
Channels
Frequency Range
y Icons Secondary Icons
Frequency Tolerance Customer
Installation
Assistance
Frequency Control
Secondary Icons
Operating Temperature Range
Notice Notice Caution Caution
Microphone
Input Voltage
Notice Caution
Current Drain
Size
Weight
Antenna Connector
Fuse
Transmitter
Power Output
Modulation
Frequency Response
Output Impedance
Receiver
Sensitivity
Selectivity
Image Rejection
Adjacent-Channel Rejection
Automatic Noise Limiter
14 English
Warranty
CB - 40 CH AM and FM
CB – 26.965 to 27.405 MHZ
0.005 %
PLL (Phase Lock Loop) Synthesizer
-30° C TO + 65° C
Plug-in Condenser
13.8VDC nom. (negative ground)
Warning
Transmit: AM / FM mod., 1.4A (Maximum)
Receive: Squelched, 0.9 A;
full audio output, 1.2A (nominal)
.98"H x 4.37"W x 4.09"D
.66 lbs. (1.37 lbs. in package)
UHF; SO-239
DC power cord inline fuse holder contains the
following fuse type: F2AL 125V - UL rated.
12V accessory charging cord contains the following
fuse type: F2AL 125V - UL rated.
4 watts
AM (Amplitude Modulation)
FM (Frequency Modulation)
300 to 3000 Hz
50 ohms, unbalanced
AM - Less than 1uV for 10dB (S+N)
FM - -120dBm @ 12 dB SINAD)
6 dB @ 7 KHz, 60 dB @ 10KHz
60 dB, typical
50 dB, typical
Built-in
Troubleshooting &
Maintenance/Adjustment
Maintenance/Adjustment
Your Cobra CB transceiver is specifically designed for the environment encountered in
mobile installations. The use of all solid state circuitry and its light weight result
in high reliability. Should a failure occur, however, review the following, then if necessary,
replace parts with identical parts. Substitution is not recommended. If you have questions,
please call Cobra Customer Care at 800-543-1608 (hours are listed on the Cobra.com website).
Check Power Source
1. Check connections to the source of power and make sure it
is the 13.8 VDC required to operate your radio.
2. Check the fuses in the DC power cord and in the 12V accessory
Check Fuses in DC Power Cord
power plug.The main power lead (red) has a 2 Amp fuse -
type F2AL 125V - UL rated in its holder. Use only the above
specified type and size fuse for maximum protection.
Failure to do so will void the warranty.
3. Make certain the microphone is properly
Check Microphone Connection
plugged in.
English
Check Antenna Connection
4. Make certain the antenna is properly assembled and connected.
If you are unable to correct the problem, please contact Cobra
customer service.
•
15