Klarstein IGNITO MAX 4 Manual page 40

EN
40
Gas connection
• This appliance must be installed and connected in accordance with installation
• regulations in force in the country in which the appliance is to be used.
• This appliance is supplied to run on LPG and natural gas. Conversion for
• use on LPG and natural gases must only be undertaken by a qualified person.
Gas supply replacement and installation guidelines:
Gas supply replacement and installation guidelines:
LPG > NG
LPG > NG
The gas inlet The gas inlet
pipe assembly
pipe assembly
G1/2"Female coupler G1/2" Female coupler
Installation of appliance
Installation of appliance
Note: Wear protective gloves
Note: Wear protective
gloves to fit the hob.
(1) Adjusting the direction of elbow
The hexagonal
The hexagonal
head of the elbow
head of the elbow
Hold still
Hold still
After loosening the elbow, adjust the elbow interface to the required direction as
required, and keep the hexagonal head of the elbow motionless with a wrench. Use a
9±1 Nm torque wrench to tighten the black bolt of the gas inlet pipe assembly. Ensure
that the torque of the wrench is within the required range to prevent elbow breakage or
damage caused by excessive force.
After the installation is tightened, check whether the parts are in good condition and test
the air tightness to ensure the tightness of the installation. The installer is responsible for
the results of the process.
Erdgas > Propan
NG > LPG
seal
seal
The gas inlet
pipe assembly The gas inlet
pipe assembly
Elbow
Elbow
Torque:
Torque
Black nut Black nut of
9±1N.m
manifold
9±1 Nm
of manifold
seal
seal
Ø1 1.5 Female coupler
Ø11.5 Female coupler
Ca u tio n!
Caution!
lf necessary to a djust or
lf necessary to adjust or
install the e lbow, it is
install the elbow, it is allowed
allowed only torque
only torque wrench with
wrench with 9±1N. m ,
9±1Nm, and work on the
and work on the Black nut
Black nut of manifold instead
of manifold instead of on
the elbow.
of on the elbow.
Tighten with a torque
Tighten with a torque
wrench of 9±1N.m
wrench of 9±1 Nm.
The black bolt of the The black bolt of the gas
gas inlet pipe assembly
inlet pipe assembly