Klarstein IGNITO MAX 4 Manual page 32

EN
32
Automatic ignition with fl ame failure safety device
• The appliance is fi tted with a fl ame failure safety device on each burner, which is
designed to stop the fl ow of gas to the burner head in the event of the fl ame going
out.
To ignite a burner
• Press in the control knob of the burner that you wish to light and turn it anti-
clockwise to the maximum position.
• If you keep the control knob depressed, the automatic ignition for the burner will
operate.
• You should hold down the control knob for 15 seconds after the fl ame on the burner
has lit. If after 15s the burner has not lit, stop operating the device and open the
compartment door and/or wait at least 1 min before attempting a further ignition
of the burner.
• After this 15-second interval, to regulate the fl ame you should continue turning the
control knob anti-clockwise until the fl ame is at a suitable level.
• The operating position MUST be at a position between the maximum and
• minimum position.
• To switch the burner off, turn the control knob fully clockwise to the gas off position.
• In case of power failure, the burners can be lit by carefully using a match.
WARNING
Danger of fi re or explosion!
If gas seems to leak, take the actions as follow:
• Do not turn on the light.
• Do not switch on/off any electrical appliance and do not touch
any electric plug.
• Do not use a telephone.
1. Stop using the product and close the middle valve.
2. Open the window to ventilate.
3. Contact our service centre by using a phone outside.