Klarstein IGNITO MAX 4 Manual page 36

EN
36
• Gently wipe the ignition device and fl ame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
• Before placing the burners back on the top plate, make sure that the injector is not
blocked.
Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown burners as
follows
For the Triple-Crown burners:
1. Place the circle burner cap(2) and burner lid(1) on the fl ame spreader(3) in tu
2. Place the fl ame spreader(5) onto the burner cup(6) and place the burner lid(4) on
the fl ame spreader(5).
3. Position the fl ame spreader(3) onto the burner lid(4).
For the Auxiliary, Semi-rapid and Rapid:
1. Place the fl ame spreader ( 4 ) on to the burner cup ( 5 ) so that the ignition device
and the fl ame supervision device extend through their respective holes in the fl ame
spreader.The fl ame spreader must click into place correctly.
2. Position the burner lid ( 1,2,3 ) onto the fl ame speader ( 4 ) so that the retaining
pins fi t into their respective recesses.
WARNING
Danger of fi re! Do not mix up the top and bottom.
The locating pins must fi t exactly into the notches.
1
2
7
3
4
8
5
9
6