Table of Contents
Advertisement
en Troubleshooting
Fault
Creasing.
The appliance is not
working.
The programme does
not start.
50
Cause and troubleshooting
Set the suitable programme for the type of fabric.
▶
Easy-Care fabrics are dried for too long.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your room or other
▶
appliances are working.
There is a software fault.
To restart the appliance, press and hold
▶
proximately 5 seconds.
has not been pressed.
Press
.
▶
Door is not closed.
Close the door.
▶
Childproof lock is activated.
Deactivate childproof lock.
▶
→ "Deactivating the childproof lock", Page 36
Finish in is activated.
Check whether
▶
→ "Buttons", Page 25
Laundry is caught in the door.
Remove any trapped laundry.
▶
The pump for the intelligent dosing system is blocked.
Put the appliance into standby mode.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 41
Switch the appliance on.
3.
If the display appears again after cleaning the
4.
pump unit, or the programme cannot be started,
call customer service.
→ "Customer Service", Page 60
Note: You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
Finish in is activated.
for ap-
Advertisement
Table of Contents
