Service Information ......16 www.U-LineService.com 2115R — Refrigerator 1 Follow Safety Precautions PLEASE READ all instructions completely before attempting to install or operate the unit.
2115R — Refrigerator 2 Inspect and Plan You have received a carton containing your 2115R Refrigerator with a package inside containing a Use and Care Guide and a Product Registration Card. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
2115R — Refrigerator 3 Prepare Site Your U-Line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for electrical connection in the rear.
Door Swing Black and White Figure 3 08/2006 2115R — Refrigerator Reversing the Door (Black and White Units Only) All U-Line units (except Stainless Steel models) may be left- or right-hand opening. The door opening is easily 34-1/8" reversed by moving the hinge hardware to the opposite side.
60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 13. Environmental Requirements Many U-Line models are designed to operate in harsh outdoor/marine environments. Special considerations include the following: • The units are designed to operate between 50°F (10°C) and 110°F (40°C).
Side-By-Side Installation Instructions For a complete refreshment center, install your 2115R Refrigerator beside a U-Line Ice Maker, Combo, or Wine Captain Model (see Figure 11 for typical cut-out). Note that each Side-By-Side Installation will be different. • Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit’s Installation Guide.
Full Overlay Door Panel Door Panel Preparation A full overlay door panel completely covers the doorframe and handle to give a built-in appearance. See your U-Line dealer for the optional Full Overlay Door Panel Kit. 2175 Models: P/N U-OL2175B -- Black P/N U-OL2175W -- White 2115 &...
Page 9
It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. 08/2006 2115R — Refrigerator Installation Instructions Removing Existing Door 1. Remove the door shelves by first pulling shelves up at a 45°...
Page 10
Figure 21. The spacers allow the original door panel to slide back into the 1/4"-thick door reveal (channel). www.U-LineService.com 2115R — Refrigerator Removed Typical Door Panel Wood Panel...
Page 11
4. Replace the door closure assembly onto the bottom pivot post (see Figure 26). Be sure that bosses on closers align with holes in hinge and hinge plate. 08/2006 2115R — Refrigerator Door Closure Top Top Pivot Plate Screw to attach Handle...
2. With door upside-down, loosen but do not remove the two screws on the door’s bottom hinge plate. Figure 28 www.U-LineService.com 2115R — Refrigerator Slotted Mounting Holes Raise Outside Door Edge Figure 29 3. See Figure 29. If the top far edge of the door needs to move UP, move the hinge plate toward the outside of the door and retighten screws.
(see Figure 32). 2. If the refrigerator is not level, adjust the feet on the corners of the unit as necessary (see Figure 33). 23 - 1/4" Figure 33 3. Check the levelness after each adjustment and repeat the previous steps until the unit is level.
Make any necessary adjustments. The unit’s top surface should be approximately 1/8" below the countertop. Relocating the Shelves Both the glass shelves in the refrigerator and the inner door shelves can be moved to accommodate your bottles, cans and containers. Glass Shelves 1.
The unit is shipped with the control preset. No adjustments should be necessary at this time. For information about Adjusting the Temperature Control, see the Use and Care Guide. 08/2006 2115R — Refrigerator Start-Up Troubleshooting Problem Unit does not appear to turn on when POWER icon is pressed.
For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in ®...