Table of Contents
Advertisement
How to Make the Connections
Using the ME-33 requires external amplification, or
headphones. To listen to the ME-33, connect it to a guitar
amp, stereo headphones, or other such sound equipment.
nhs
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn
off the power on all devices before making any
connections.
Stereo Headphones
AC Adaptor
(BOSS PSA-series: optional)
Multitrack Recorder
Guitar Amplifiers
When using the ME-33 in mono, such as to the input of a
guitar amp connect a cable to the OUTPUT L (MONO) jack
only.
Do not use a cable containing a resistor to connect CD or MD
players to the AUX IN jack.
When using battery power, connect the batteries according to
the instructions in "About Changing Batteries" (p. 38).
When using the ME-33 with the an AC adaptor, be sure to use
only a BOSS PSA-series adaptor. Use of other adaptors may
result in overheating and possible damage to the unit.
If there are batteries in the unit while the AC adaptor is being
used, normal operation twill continue should the line voltage be
interrupted (power blackout or power cord disconnection).
To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
Turning on the Power
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
(CD/MD Player)
L
ME-33
L
Guitar Amp / Stereo, Multitrack Recorder, Etc.
*
Turn up the volume on amps and other equipment only after
all connections are completed and the power for connected
devices is turned on.
This unit is equipped with a protection circuit. A brief interval
(several seconds) after power up is required before the unit will
operate normally.
*
When the ME-33 is operating on battery power only, "BATT
L" appears in the LCD's character display area when the
batteries begin to run low. Replace the batteries when this
occurs.
Making the Settings for the
Connected Device (Output Select)
In order to get the most from the COSM amp modeling
technology in the ME-33, match the ME-33's output to the
type of amplification devices being used.
Each time [LINE/G.AMP] is pressed, the square ("Ml")
toggles between positions to the left of LINE and G.AMP in
the LCD screen's output select area.
LINE:
Select LINE for listening through headphones,
playing through a PA system, or recording to a
Audio/ multitrack recorder.
G.AMP: _ Select this setting when the ME-33 is connected toa
guitar amp.
Advertisement
Table of Contents
