Exterior Cleaning; Cut-Out Dimensions - U-Line Echelon 2075DWRRSS Installation Manual

Exterior Cleaning

(As Required)
Black Models:
• The drawers, grille and cabinet may be cleaned with a
mild detergent and warm water solution. Do not use
solvent-based or abrasive cleaners. Use a soft sponge
and rinse with clean water. Wipe with a soft, clean
towel to prevent water spotting.
Stainless Steel Models:
• Stainless steel models can discolor when exposed to
chlorine gas, pool chemicals, salt water or cleaners with
bleach.
• Keep your stainless steel unit looking new by cleaning
with a good quality all-in-one stainless steel cleaner/
polish on a monthly basis. For best results use Claire
Stainless Steel Polish and Cleaner, which can be
purchased from U-Line Corporation. (The part number
is 173348.) Comparable products are acceptable.
Frequent cleaning will remove surface contamination
that could lead to rust. Some installations may require
cleaning on a weekly basis.
• Do not clean with steel wool pads.
• Do not use cleaners that are not specifically
intended for stainless steel (this includes glass,
tile and counter cleaners).
• If any surface discolors or rusting appears, clean it
quickly with Bon-Ami or Barkeepers Friend Cleanser
and a non-abrasive cloth. Always clean in the direction
of the grain. Always finish this process with Claire
Stainless Steel Polish and Cleaner or comparable
product to prevent further problems.
• Use of abrasive pads such as Scotchbrite will
cause the graining in the stainless to become
blurred.
• Rust that is allowed to linger can penetrate into the
surface of the stainless steel and complete removal of
the rust may not be possible.
www.U-LineService.com
2075DWRR — Drawer Model Refrigerator
3 Prepare Site
Your U-Line product has been designed for built-in
installation. Your unit does not require additional air
space for top, sides or rear. However, the front grille must
NOT be obstructed and clearance is required for electrical
connection in the rear.
Note: Unit can NOT be installed behind a closed cabinet
door.

Cut-Out Dimensions

34-1/4"
to
35-1/8"
Figure 1
Follow the cut-out drawing in Figure 1. The 24-3/16"
width allows 1/4" for ease in installation and removal of
the unit. 24" is the counter depth in most installations.
The unit is 23-11/16" deep including the drawer and not
the full handle or 3/4" overlay (see Figure 2).
4
™
See Electrical
Specifications
for Power Supply 23-11/16"
24-3/16"
02/2005