Recording Procedures - Nakamichi 500 Operating Instructions Manual

Record Procedures
1. Open the Cassette Lid upon depressing
the Stop/Eject Button.
2. Put the cassette in the compartment,
full reel of tape on your left.
3: Set the EQ and Bias to those of the
tape (Refer to Fig. 9).
4, Limiter Switch
Prevents distortion particularly while
live recording.
5
ng
Sen Eas 2
5. Set the Switch to IN while recordi
with Dolby NR IN.
(Refer to page 8 for Test Tone.)
6
ine filter Nakamichi 500
Dual-Tracer
vokage AC 100:17220,240voies
e 50/60 He
23 worts
ARCH INC.
aoe
Nhat
6. When recording from FM Stereo
Broadcasting, set the MPX Filter at the
rear panel to ON.
7. Push the reset button to set the
Counter to '000'. Then set the
Memory Switch to ON at the starting
point of recording.
9. Depress the Play Button while the
record button is being pushed.
The Record Lamp will then illuminate
showing recording is ready.
10. Adjust the Line Input Level. (Refer
to page 10 Level Adjustment.)
OOMOOG
11. When level setting is completed,
start the tape upon pushing the Pause
Button. ;
))
Coane Co
d fa
12. When recording is finished, stop the
tape by pushing the Stop Button.
13. When the tape comes to an end, tape
run will automatically stop and the
push button will also be released.
A cassette has 'tabs' as illustrated below,
on the side opposite to that exposing the
bare tape. If you break them off with a
screwdriver or the like of it, the cassette
will prevent the depression of the RECORD
Button, thus eliminating the possibility of
erasing a valuable recorded cassette by
mistake. Take advantage of this feature
when you want to preserve a cassette into
which you've made important recordings.
If you want to preserve the recording in
only one side, break only one of the tabs,
referring to the illustration below.
Note:
Should you ever want to make a recording
into a cassette with such tabs already
broken, seal the tab openings with masking
tape or plug it with eraser rubber, etc.