Table of Contents
Advertisement
The Battery
Installing the Battery
Note
Yii
Note
3
Your cardiograph requires the battery to be installed for
proper operation-even if the cardiograph is plugged into
AC power, it cannot operate without the battery.
Use only HP batteries, part number M2460A, in the
cardiograph.
To install the battery:
Do not remove the shrinkwrap surrounding the battery.
When you install the battery you may notice a screw
hole located near the battery compartment. This screw
hole is the mounting point for the optional
M1705B
cart.
The mounting thumbscrew is supplied with the cart.
1. Make sure the cardiograph is unplugged from AC
power.
2. Turn the cardiograph bottom-side up.
3. Slide the battery door in the direction of the arrow
until it unlatches (approximately l/2 inch), as shown
in Figure A-2. Lift off the door.
4. Install the new battery in the battery compartment as
shown in Figure A-3 and plug the battery connector
into the cardiograph.
5. Place the battery door into its slots and slide the door
in the opposite direction of the arrow until it latches,
as shown in Figure A-2.
6. Turn the cardiograph top-side up.
7. Plug the cardiograph into -4C power.
8. Check that the AC indicator light is on. The unit is
now in Standby (off) mode with the battery charging.
After you finish setting up the cardiograph, it may be
used on a limited basis until the battery has been fully
charged. Hewlett-Packard recommends charging the
A-4 Setting up Your Cardiograph for the First Time
Advertisement
Table of Contents
