Checking The Voltage Setting - HP PageWriter 100 User Manual

Checking the
Voltage Setting
Your cardiograph can be set to operate at nominal line
voltages of 115 or 230 Volts (see the following Note).
The line voltage was set at the factory to the setting
for your area. However, it is a good idea to check this
setting. Refer to Figure A-l for the physical location of
the voltage select switch. To check the voltage setting,
perform the following steps.
1.
2.
3.
Locate the voltage select switch on the back of the
cardiograph. See Figure A-l.
Verify that the correct voltage is visible on the
voltage select switch. If the voltage setting is
incorrect, slide the voltage switch so the correct
voltage is visible. The cardiograph operates with any
line frequency from 50 to 60 Hz.
Remove and discard the label that covers the AC
power receptable. See Figure A-l for the location of
the AC power receptable. The purpose of the label
is to remind you to check the setting of the voltage
select switch.
Caution The cardiograph can be damaged if plugged into the
incorrect voltage.
A-2 Setting
up
Your Cardiograph for the First Time