Honeywell NOTIFIER INSPIRE E10 Operating Instructions Manual page 13

Day or Night Mode operation
The Toggle function, if configured for your system, will allow a change between Day Mode and Night Mode. The
Day Mode is made active on preselected days of the week over preselected time period. Outside the Day Mode the
Night mode is automatially made active.
When the Day mode is active the 'Delay Active' LED is lit
The switch between Day mode and Night mode is possible using the Toggle button during Normal
'SAFE' condition. During event condition such as with an active Fault or Disablement event, then this
toggle functionality is accessible using the menu, see "Day/Night Mode Settings" on page 30..
Day mode
During the Day Mode and upon detection of a Fire the activation of alarm output is delayed to allow the incidence
to be investigated. Commonly a short delay is applied which can be extended using the
active delay can be stopped by selecting the
Night Mode
In the Night Mode the sensors operate normally and upon detection of fire the alarm outputs are activated
without delay.
Select the 'Toggle' button to change from Day Mode to Night Mode, the display shows Night Mode is Active.
INSPIRE E10/E15 Control Panels - Operating instructions
and the LED is Off during Night Mode
button.
button. Any
13