General Safety Rules; Safety Instructions - Black & Decker BCL350 Instruction Manual

ENGLISH
DO NOT RETURN THIS PRODUCT TO THE STORE,
first contact your local BLACK+DECKER office
or nearest authorized service center.
CONSERVE TODAS LAS ADVERTENCIAS
E INSTRUCCIONES PARA FUTURAS
CONSULTAS

WARNING! Read and understand all instructions.
Failure to follow all instructions listed below, may result
in electric shock, fire and/or serious personal injury.

GENERAL SAFETY RULES

SAFETY INSTRUCTIONS


General power tool safety warnings.
Warning! Read all safety warnings and all instructions.
Failure to follow the warnings and instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference. The
term "power tool" in all of the warnings listed below refers
to your mains operated (corded) power tool or battery
operated (cordless) power tool.
• Read all of this manual carefully before using the
appliance.
• The intended use is described in this manual. The use
of any accessory or attachment or the performance
of any operation with this appliance other than those
recommended in this instruction manual may present a
risk of personal injury.
• Retain this manual for future reference.
Using your Appliance
Always take care when using the appliance.
a ) This appliance is not intended for use by young or
infirm persons without supervision.
b ) The appliance is not to be used as a toy.
c ) Use in a dry location only. Do not allow the unit to
become wet.
d ) Do not immerse the appliance in water.
e ) Do not open body casing. There are no user-
serviceable parts inside.
f ) Do not operate the appliance in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust.
g ) To reduce the risk of damage to plugs and cords never
pull the cable to remove the plug from a socket outlet.
After Use
h ) When not in use, the appliance should be stored in a
dry, well ventilated place out of the reach of children
i ) Children should not have access to stored appliances
j ) When the appliance is stored or transported in a
vehicle it should be placed in the boot or restrained
to prevent movement following sudden changes in
speed or direction.
14
k ) The appliance should be protected from direct
sunlight, heat and moisture.
Inspection and Repairs
l ) Before use, check the appliance for damaged or
defective parts. Check for breakage of parts, damage
to switches and any other conditions that may affect
its operation.
m ) Do not use the appliance if any part is damaged or
defective.
n ) Have any damaged or defective parts repaired or
replaced by an authorised repair agent.
o ) Never attempt to remove or replace any parts other
than those specified in this manual.
Service
p ) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
Electrical Safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main voltage
corresponds to the voltage on the rating plate.

WARNING! If the power cord is damaged,
it must be replaced by the manufacturer,
authorized BLACK+DECKER Service Center or
an equally qualified person in order to avoid
damage or injury. If the power cord is replaced by
an equally qualified person, but not authorized by
BLACK+DECKER, the warranty will not be valid.
Labels on Tool
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per
minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation