AEG 3000 Series User Manual page 53

- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones even if
you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
6.5 Automatic Heat Up
Use the function to get a desired heat setting
in a shorter time. When the function is on, the
cooking zone operates at the highest heat
setting in the beginning and then continues to
operate at the desired heat setting.
To activate the function the cooking zone
must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the heat
setting.
6.6 PowerBoost
This function makes more power available to
the induction cooking zones. The function can
be activated for the induction cooking zone
only for a limited period of time. After this time
the induction cooking zone automatically sets
back to the highest heat setting.
Refer to "Technical data" chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: change the heat
setting.
comes on). Immediately
comes on.
6.7 PowerBoost with a double ring
cooking zone
The function is activated for the inner ring
when the hob detects a pot with a diameter
smaller than the inner ring. The function is
activated for the outer ring when the hob
detects a pot with a diameter bigger than the
inner ring.
6.8 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking zone,
then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function: touch
timer to set the time (00 - 99 minutes). When
the indicator of the cooking zone starts to
flash, the time counts down.
To see the remaining time: touch
the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
To change the time: touch
cooking zone. Touch
To deactivate the function: touch
the cooking zone and then touch
remaining time counts down to 00. The
indicator of the cooking zone disappears.
When the countdown ends, an acoustic
signal sounds and 00 flashes. The
cooking zone deactivates.
To stop the sound: touch
• CountUp Timer
You can use this function to monitor how long
the cooking zone operates.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
of the
to set
to set the
or .
to set
. The
.
ENGLISH 53