Advertisement
(2)
Cut off the inner cable covers of the iris control
cable as shown in the diagram,
Approximately
6 mm
Put the heat shrinkable tubes or equivalent tubes
on
the inner cables
of the iris control cable.
Solder the inner cables of the iris control cable at
the pin-plug block according to the following pin
assignment and cover the heat shrinkable tubes
or equivalent tubes at soldered area and the heat
on the tubes to shrink.
Pin
1: Power
Source
: +9V
DC, 5OmA
Max.
Pin 2: Not used
Pin 3: Video Signal : 0.7Vp-p/40kohms
Pin 4 : Shield, Ground
(When the Lens Selection Switch (8) is set to the
VIDEO position)
Pin 3
Pin 1
ae |e
(5)
Both
the connector
cover and connector
should
be positioned to interlock,
Connector
Cover
Heat
Shrinkable
Tubes
Iris Control
Cable
Note : Cut off the rib on the connector,
when
the iris control
cable
is thick and the
connector
cover and connector can not
locked,
Advertisement
