Advertisement
When
you
use the lens other than listed on pages 9
and
10, lens mount
should
be C-mount
or special
C-mount
(CS
mount
(1"-32UN))
and
lens weight
should be less than 0.92 Ibs (420g).
If not, both the
lens and camera should be secured.
The protrusion of the rear of the lens should be as
shown below.
C-mount:
Less than 11.5 mm
|
CS mount:
Less than 7.2 mm
2. Installation of Auto fris Lens Connector
When you use the Auto Iris Lens other than listed.on
page
9, install
the lens connector
(YFE4191J100)
comes with the camera as follows.
The following installation should be made by qualifi-
ed service personnel or system installers.
(1) Cut off the iris control cable at the edge of lens
connector and then cut off the outer cable cover
as shown in the diagram,
lris Control
Cable
Cut Off
Lens Connector
16"
(A
i
|
Iris Control Cable
Bile
{Approximately Sminy
es ee
Advertisement
