Electrical Connectiom .Ee - Panasonic CQ-VA70EU Operating Instructions Manual

Electrical Connection
Before Wiring
* To prevent damage to the unit, be sure to follow the connection diagram below.
¢ Be sure to insulate any exposed wires against possible short-circuit from the car chassis. Bundle all ca-
bles and should not be disconnected. Therefore, extra care should be taken to prevent short-circuits.
¢ Do not insert the power connector into the unit until the wiring is completed.
Note:
For installation in cars with trip or navigational computers, all electronic memory settings previously registered
in the computer will be lost when the battery terminal is disconnected. Do not disconnect the battery in vehi-
cles equipped with these units. Therefore, extra care should be taken to prevent short-circuits.
<Basic Wiring>
Front main input
cord
Asar main input
cord
CQ-VA70 (Tuner Unit}
QOOOOCO
© ©
© © © ©
CO changer connector
` See page 41 when
connecting the side-brake
detection cord and the
reverse cord.
Display unit connector
(Btack} j
Ground lead
Power
connector (SIDE BRAKE) (Blue w/yellow stripes)
cue (FRONT L) Side-brake
(Lett) = detection cord
oe = eee wiblack cand
cord o cami")
L eon
ff
; ;
(Right}
{Violet wiwhite stripes}
9 m 7s Reverse cord
{Gray w/black stripes)
@ maN ee 人 (Green) ee AR aly
(Left) aa
Rear Control cord
speaker me wholack stripes) tor extemal unit
cord cs: saa (Violet) (REAR af
(Right man eenn S
(Violet w/black stripes) (EXT PLAY/STOP CONT) (Brown wblack _ Control cord
for external unit
Ground lead sm FLAWSTOR
Radio antenna
Auto antenna (Plun). (ANT-CONT MAX'0:1A) | receptacle
control power cord
{Blue wiwhite stripes) {AMP-CONT MAX 0.14)
Extamal amp a C
control power cord
(Orange) {NAVI MUTE)
NAVI mute cord C
{Brown w/white ages) (TWIN CD + C-CONT)
Twin CD changer C
control cord
(Red} ace 3A) al
Accessory power cz] gp
cord
{Yallow) GATEN t0A) Fuse
Battery power cord = 64 TD
CO-VA7O
{Display unit)
Note:
Connect the battery cable to a terminal that is
always live.
36
Note:
Do not connect this auto antenna control power
cable to the power terminal that directly drives the
auto antenna. (Otherwise, trouble may occur.)