Panasonic CQ-VA70EU Operating Instructions Manual page 41

E
N
G
L
|
S
H
Connecting the Side-brake Detection Cord
Note:
w ©
Make sure to connect the side-brake cord to ensure safety and prevent accidents.
* Out of the two cords coming from the side-brake switch, connect the cord that is normally not earthed on
the chassis (when the side-brake is released.)
Foot brake
Hand brake
* Make sure to connect the side-brake cord (blue/yellow) to the wiring of the side-brake switch.
* The position of the side-brake switch can differ according to the car model. An example is shown below.
Detailed information is obtainable from the car dealer.
Side-brake switch
Side-brake switch
(SIDE BRAKE)
Side-brake cord /5m r
(Blue/yellow) Crimp connector
Connecting the Reverse Cord
Connect the reverse cord (violet/white) to the plus
wire of the backup light. The backup light (with a
clear lens) is located at the rear of the car and lights
when the gear lever is put into reverse (R).
*
Location of backup lamp
P
Cut off here. | a g
NI
(REVERSE) 4
D
* The backpup light wiring can be
= reached from the trunk,
REVERSE cord /4m
(violet/white}
41
CQ-VA70EU