Related Manuals for Watts HYDROGUARD HG210
Summary of Contents for Watts HYDROGUARD HG210
- Page 1 HG210 HG220 Installation and Operating Instructions For correct operation of this product, it is essential to observe these instructions...
-
Page 2: Table Of Contents
Contents Introduction ..........................2 General Warnings and Safety Information ..................3 General ............................ 3 Mechanical ..........................3 Product Information ........................4 Features ........................... 4 Product Specifications ......................4 Parts Included ..........................5 Installation Instructions ......................... 6 Water supply Requirements ....................... 6 Environment Requirements ....................... -
Page 3: General Warnings And Safety Information
General Warnings and Safety Information General • Do not use with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection. • The product must be installed in an upright position, it cannot be installed in any other orientation. -
Page 4: Product Information
Product Information Features • Pre-assembled for easy assembly • 2-stage filtration for excellent water quality: ▪ 5-micron sediment filtration ▪ Chlorine, taste and odour treatment (CTO) • Brass fittings for extra strength • No power required Product Specifications HG210 HG220 Water Supply 1-40°C water only from tank, bore or mains supply Ambient Temperature... -
Page 5: Parts Included
Parts Included For quick and easy installation, the product components come assembled. Before installing the product, please check all contents are present and undamaged. All connections must be checked for leaks before operating the product. Product Code Product Code Item Description HG210 HG220... -
Page 6: Installation Instructions
Installation Instructions Water supply Requirements • Cold water inlet only, working water temperature 1-40 °C. Protect from freezing at all times. • Supply pressure ≤500kPa. An approved pressure limiting valve must be installed by a licensed person in situations where supply pressure could exceed 500kPa. •... -
Page 7: Mounting Installation
Mounting Installation Installation steps: 1. Mark the desired location for the mounting fixings. See Product and Position Preparation 2. Drill the holes and install the anchors (not included). 3. Align the mounting plate with the anchors and lower into place. 4. -
Page 8: Maintenance Instructions
Maintenance Instructions Before any maintenance turn off the water supply to the product and open a downstream fixture for a few minutes or until the water flow stops. Close the downstream fixture, and then press the red buttons on top of the filter housing caps to release the pressure in the system. You may now begin maintenance. -
Page 9: Spare Parts List
Remove any fittings, clean all threads thoroughly and inlet or outlet reseal with thread sealant tape and tighten. Filter cap is damaged, causing a Contact Watts for a replacement if the part has been leak overtightened, exposed to freezing, high pressure or other damage. - Page 10 Contaminants in Filter cartridges are at Cartridges should be replaced every 6-12 months the outlet water capacity depending on water quality. See Filter Cartridge Replacement. Contamination in the filter Remove the filter housings, clean the housing with dish housings soap and warm water, rinse thoroughly and then reassemble.
-
Page 11: Limited Warranty
Watts will, at its option, replace or recondition the product without charge. Watts shall in no way be liable for any loss, damage (direct, indirect or consequential), cost or expense incurred other then those rights a consumer has under the Consumer Guarantees Act 1993. -
Page 12: Maintenance Log
Maintenance Log Stage 1 Filter Stage 2 Filter Date Serviced By Replace at least every 1 year or as required Replace at least every 1 year or as required 12 | P a g e...