Table of Contents
Advertisement
7.4 LW ALIGNMENT PROCEDURE
(BAND switch in "LW" and FUNCTION switch in "RADIO/AUX"'.)
Connect Signal
Generator to:
Set Signal
Frequency to:
Indicator
Connection
Set Tuning
Dial to:
CRS-2104
Procedure
Indirect coupl-
145 kHz with
modulation.
145 kHz (max.
capacitance).
VTVM
across EXT
ing near set
antenna coil
380 kHz with
modulation.
SP4Q.
380 kHz (min.
capacitance).
Adjust for max. output.
Repeat Steps 1 and 2.
Indirect coupl-
170 kHz with
modulation.
170 kHz.
VTVM
across EXT
ing near set
antenna coil
320 kHz with
modulation.
SP 42.
320 kHz.
Adjust for max. output.
7.5 SW ALIGNMENT PROCEDURE
Repeat Steps 4 and 5.
(BAND switch in ""SW'' and FUNCTION switch in "RADIO/AUX"'.)
Connect Signal
Generator to:
Set Signal
Frequency to:
Indicator
Connection
Set Tuning
Dial to:
indirect coupl-
ing near set
antenna coil,
5.5 MHz with
modulation.
aes Be
5.5 MHz
(max.
capacitance).
VTVM across EXT
19 MHz with
modulation.
19 MHz (min.
Sega.
capacitance).
Repeat Steps 1 and 2.
Procedure
Adjust for max. output.
Indirect coupl-
2
|
ing near set
i
7 MHz with
modulation.
|
VTVM
across EXT
antenna coil.
16 MHz with
modulation.
SP42.
Adjust for max. output.
NOTE:
Repeat Steps 4 and 5.
1. In adjustment, connect the signal generator grounding terminal (—) to that of the set.
. Modulate the signal generator to 30% with a 400 Hz signal.
2
3. Reduce the signal generator as low as possible.
4 . Set the VOLUME
control for the maximum
level.
13
Advertisement
Table of Contents
