Moving The Heater - Honeywell HCE300 Series Owner's Manual

19. WARNING ALWAYS plug heater directly into
a wall outlet/receptacle. DO NOT use with an
extension cord or relocatable power tap
(outlet/power strip).
20. WARNING NEVER tamper with this product
or attempt to fix it. Any tampering with, or
modification of this product can result in serious
injury, death, or fire. DO NOT open. Risk of electric
shock. There are no user serviceable parts inside.
21. WARNING DO NOT remove product labels
that contain warnings or safety instruction.
22. CAUTION The output of this heater may vary
and its temperature may become intense enough
to burn exposed skin. Use of this heater is not
recommended for persons with reduced sensitivity
to heat or an inability to react to avoid burns.
23. CAUTION Before cleaning, or storage, or when
not in use, turn the product's controls to the OFF
HCE323/HCE353 SERIES ONLY
WARNING: CHEMICAL BURN HAZARD.
Keep batteries away from children. This product contains a lithium button/coin cell battery. If a new or
used lithium button/coin cell battery is swallowed or enters the body, it can cause severe internal burns
and can lead to death in as little as 2 hours. ALWAYS completely secure the battery compartment. If the
battery compartment does not close securely, stop using the product, remove the batteries, and keep it away
from children. If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention. The cells must be disposed of properly, including keeping them away from
children; even used cells may cause injury.
ABOUT CERAMIC TECHNOLOGY
Ceramic heaters generate heat by passing electricity through heating wires embedded in ceramic plates.
In the Honeywell Ceramic Tower Heater, air is drawn into the back of the heater by a fan, through the ceramic
element and out the front of the heater to gently introduce warm air into the room.
This type of heating technology provides consistent, even heating.
For best results, place heater on the floor and allow heater to run for 5-10 minutes to reach maximum heat output.
SET UP
The Honeywell Ceramic Tower Heater requires no assembly. Simply unpack heater and save all packaging
materials for off-season storage.
Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall
or combustible material.
DO NOT use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE A TRIPPING HAZARD.

MOVING THE HEATER

This heater is equipped with a Cool Touch handle for your convenience.
Turn off the heater.
Allow it to cool for ten minutes.
Unplug heater and move.
position and unplug the heater from the electrical
outlet and allow to cool.
24. CAUTION Place the heater on a firm, level, open
surface free from obstructions and at least 3 feet
(0.9 m) away from any combustible materials. DO
NOT use on an unstable surface such as bedding
or deep carpeting. Be sure the heater is not in a
position where it may be tripped over by small
children or pets.
25. CAUTION If your home has aluminum wiring
have a licensed electrician check your receptacle's
connections. When using a 1500 watt heater,
aluminum wire connections can cause a safety
issue.
SAVE THESE INSTRUCTIONS.
3