Care And Cleaning; Troubleshooting - Hinkley SCULPT 80 Instruction Manual

CARE AND CLEANING

Periodically it may be necessary to re-tighten blade to blade arm screws or blade arm to motor screws to prevent clicking or humming
sound during operation. This is especially true in climates with broad temperature and humidity ranges.
When dusting the blades, you must support the blade to prevent bending - no pressure should be applied to the blades. If you experience
any flaws in the operation of your fan, please check the following points.

TROUBLESHOOTING

PROBLEM SOLUTION
FAN WILL 1. Check to assure that a new batteries is installed in the remote or wall control. Check circuit fuses or breakers.
NOT START
2. Check wall control LED indicator light. If LED is not illuminated when pushing a button, it is not transmitting a
signal. Please check battery, power to wall control/circuit breaker and all electrical connections.
3. Assure that there are no more than 12 fans operating on a circuit through an on/off wall switch or a breaker (not
through a wall control).
4. Assure that the fan in within range of the WiFi (150 ft.) or wall control (30 ft.).
FAN SOUNDS 1. Allow a 24-hour "breaking-in" period. Most noise associated with a new fan will disappear during this time.
NOISY
2. Make sure all motor housing screws are securely fastened.
3. Make sure the screws that attach the fan blade to the fan are tight.
4. Make sure your ceiling box is secure and rubber isolator pads are used between the mounting bracket and outlet
box.
FAN WOBBLES 1. Check that all blade to motor and blade arm screws are secure.
2. If the blade wobble is still noticeable, interchanging two adjacent (side by side) blades can redistribute the weight
and possibly result in smoother operation.
3. Make sure the mounting plate is securely fastened to the ceiling outlet box.
4. Make sure ceiling box is secure.
Switch off power supply before carrying out any of these checks.
CAUTION:
©2023 Hinkley Lighting, Inc. | hinkley.com | 17