Pioneer XR-J11 Operating Instructions Manual page 2

IMPORTANT
JlL
The lightning flash with arrowhead, within an equilateral
triangle, is intended to alert the user to the presence of
uninsulated "dangerous voltage" within the product's
e ndosure th at may be of sufficient mag nitude to co nstitute
a risk of electric shock to persons.
CAUTION
RSSK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL
A
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating end maintenance (servicing) instructions in
the literature accompanying the appliance.
IMPORTANT
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in
accordance with the following code:
blue neutral
brown live
If the plug provided is unsuitable for your socket
outlets, the plug must be cut off and a suitable plug
fitted.
The cut-off plug should be disposed of and must not be
inserted into any 13 amp socket as this can result in
electric shock. The plug or adaptor or the distribution
pane! should be provided with 5 amp fuse. As the
colours of the wires in the mains lead of this appliance
may not correspond with coloured markings
identifying the terminals in your piug, proceed as
follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Do not connect either wire to the earth terminal of a
three pin piug.
NOTE
After replacing or changing a fuse, the fuse cover in the
plug must be replaced with a fuse cover which
corresponds to the colour of the insert in the base of
the plug or the word that is embossed on the base of
the plug, and the appliance must not be used without a
fuse cover, if lost replacement fuse covers can be
obtained from: your dealer.
Only 5 amp fuses approved by B.S.I. or A.S.T.A. to B.S.
1362 should be used.
[FOR EUROPEAN AND U.K. MODELS]
The following caution label appears on your unit
CAUTION
This product contains a laser diode of higher class than 1. To
ensure continued safety, do not remove any covers or attempt to
gain access to the inside of the product.
Refer all servicing to qualified personnel.
Location: rear of the unit.
CLASS 1
LASER PRODUCT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used .in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
2
<ARB7008>