Pioneer DC-Z85 Operating Instructions Manual page 3

CONNECTIONS
2 | 3
CD player &
Tuner
~N Q Speaker cord ae
€ at ae
L— 7
10mm
3 s Push away.
1 = Cutter 2 = |
|
|
j
Twist the strands.
4 a Pull back.
Refer to page 2 for the connections diagram
@ Accessory FM antenna
Accessory AM loop antenna
FM/AM tuner (F-Z95)
Turntable (PL-Z85, etc.)
Tuner input/output cord
Surround speaker system
CD player flat cable
Cassette deck amplifier (DC-285)
Turntable power, supply cord
Speakers cord
Speaker system
Power. cord
CD player (Separately sold PD-265, PD-Z75T or PD-Z285M)
LD player or video cassette recorder (VCR)
To the AC wall socket
@ Audio cord (White)
@ Audio cord (Red)
EI
SSS8SSG898O9808
| Plug the power cord into the household electrical outlet only after
| all the connections have been completed.
Proceed as follows with the set up and connections.
1. Place the cassette deck amplifier on top of the CD player.
2. Connect the CD player OUTPUT jacks to the cassette deck
amplifier CD INPUT jacks with audio cords.
If using this unit together with the optional CD player PD-Z65, PD-
2757 ot PD-Z85M, connect the flat cable @.
3. Place the tuner on top of the cassette deck amplifier.
4, Connect the tuner input/output cord D to cassette deck am-
plifier,
TUNER AND CD PLAYER CONNECTIONS (Fig. [2))
2 »ctor until it locks, thus ensuring that it is con-
disconnecting the connector, pull itin the opposite
direction while pressing the left and right claws.
NOTE:
When connecting or disconnecting the input/output cable, da so only
after disconnecting the power plug from the walf socket.
5. Connect the FM antenna @ and the AM loop antenna © to the
tuner's antenna terminals.
6. Place the turntable on top of the tuner.
% Connect the turntable power supply cord © and audio cords
© @ to the cassette deck amplifier's jacks.
If using the turntable PL-Z85, connect the turntable's audio cords
and power supply cord respectively to the cassette deck ampli-
fier's PHONO jacks and DC 12V OUTPUT jack.
If using a different turntable, connect its audio cord and ground
cord.
8. Use the "LD/VCR" jacks for connection to the audio output
jacks of an LD player or VCR.
NOTE:
* Insert the plugs securely into the jacks. Improper connection car
lead to sound distortion or mattunction.
® The white plug is for the left channel connection and the red plug for
the right channel connection.
9. Connect the speaker cords (2 to SPEAKERS terminals.
Fig. [3])
Connect the "+-" terminals on the cassette deck amplifier to the
"+" terminals on the speakers, the "—" terminals on the c .
deck amplifier to the "—" terminals on the speakers
NOTE:
Do not allow the conductors of the cords to project out of the termi
nats or to come into contact with other conductors. Attreakdown or
failure may occur when conductors touch, anes
Speaker impedance
Connect speaker systems with a nominal impedance ranging trom6
to 16 Q.
Surround speaker connection
Connect the plugs properly.
Connect a speaker system having a
nominal impedance of 16 Q or more.
10. Connect the CD player's power cord to the deck amplifier's
AC OUTLET.
11. Finally, connect the power cord @ to the AC wall socket.
<ARB1354