Installation - Indesit INC 871 Instructions For Use Manual

– If the refrigerating appliance is
left empty for long periods, switch
off, defrost, clean, dry, and leave
the door open to prevent mould
developing inside the appliance.

INSTALLATION

The appliance must be handled
and installed by two or more
persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including water
supply (if
connections and repairs must be
carried out by
technician. Do not repair or replace
any part of the appliance unless
specifically stated in the user
manual. Keep children away from
the installation
unpacking the appliance, make
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest After-sales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.) must
be stored out of reach of children
- risk of suffocation. The appliance
must be disconnected from the
power supply
installation operation - risk of
electrical shock.
During installation, make sure the
appliance does not damage the
power cable - risk of fire or
electrical shock. Only activate the
appliance when the installation
has been completed.
Be careful not to damage the
floors (e.g. parquet) when moving
the appliance. Install the appliance
any), electrical
a qualified
site. After
before any
on a floor or support strong
enough to take its weight and in a
place suitable for its size and use.
Make sure the appliance is not
near a heat source and that the
four feet are stable and resting on
the floor, adjusting them as
required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on,
to ensure that the refrigerant
circuit is fully efficient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or
fixing of the appliance must be
done in accordance with the
manufacturer instructions.
It's forbidden
refrigerator in such way that the
metal hose of gas stove, metal gas
or water pipes, or electrical wires
are in contact with the refrigerator
back wall (condenser coil).
All dimensions
needed for installation of the
appliance are in the Installation
Instruction booklet.
Please remove the power cord
from condenser hook during
installation before connecting
product to power supply.
ELECTRICAL WARNINGS
It must
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-
pole switch installed upstream of
the socket in accordance with the
7
to place the
and spacing
be possible to