Log In To The Router After You Set Up The Router; Change The Language - NETGEAR Nighthawk RS700 User Manual

If the router does not detect the Internet settings, the installation assistant cannot
complete the installation process, and you must start the installation process again:
1. Before you start again, review your settings. Make sure that you select the correct
options and type everything correctly.
2. If the router still does not detect the Internet settings, contact your ISP to verify that
you are using the correct configuration information.
3. If problems persist, register your router and contact NETGEAR Technical Support.

Log in to the router after you set up the router

When you set up your router while the router is in factory default state, the browser
automatically starts the NETGEAR installation assistant.
After you set up the router, if you want to view or change settings for the router, you
can use a browser to log in to the router web interface.
To log in to the router web interface:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
NOTE: You can also enter http://www.routerlogin.com or
http://192.168.1.1. The procedures in this manual use
http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.

Change the language

By default, the Auto setting uses your region to automatically set the language that
displays when you log in to the router web interface.
Connect to the Router Network
and Access the Router
Nighthawk WiFi 7 Tri-Band Router Model RS700
30 User Manual