Table of Contents
Advertisement
Inserting the Battery
1
Press (indentation) and slide down the
battery cover.
2
Unpack the battery ensuring that the rib
on the battery fits into the groove of the
case.
3
Plug the connector into the socket.
4
Replace the battery cover.
To remove the Battery
First power off and wait until the display goes blank. Follow steps 1 to 4
above, unplugging the connector and removing the battery in steps 2-3.
Warning
Never pull the battery cable at an angle nor pull the battery to unplug the
connector.
Charging the Battery
As supplied, your battery will not be fully charged.
1 Plug the Charger into a mains socket.
2 Plug the Charger into the bottom
(jack) of your CMD-C1.
The status bar in the battery icon on the display indicates the
charging status. Charging (0 °C - 45 °C) is complete when the battery icon
indicates all bars. Full charging can take up to 5 hours, but may vary
depending on certain conditions e.g. if your CMD-C1 is switched on,
temperature is outside the operating range. As an energy-saving measure,
disconnect the charger from the mains socket and then from the phone
after charging.
Important
Use only the Sony-specified CMD-C1 battery and charger. The battery must be
connected during charging.
Usage Time
When your battery is weak, the battery icon in the display flashes and
there is a beep indicating that only one minute of talk-time is left.
To mains
GB
9
Advertisement
Table of Contents
