Self-Clean Cycle - Kenmore 911.9554591 Owner's Manual

SELF-CLEAN CYCLE
continued
I, Slide the door lock handle to the lock
position., Neverforce the handle, If it does
not sfide easily, you may not have pulled
the handle out from the lock cover far
enough.
2, Turn the Oven Control Knob to the CLEAN
position.
If you turn the Oven Control Knob to clean
before locking the door the Lock Door
indicator light will flash,
The clean cycle wil! last 4 hours and 20
minutes. If you want to change the length of
clean time between 3 hours to 5 hours and 59
minutes:
m
u
While the : (colon) is flashing in the disp/ay,
press the Hour and!or Min Up or Down
arrow pad°
When the cycle is finished, both the Oven
On and Lock Door indicator lights will
flash,, Turn the Oven Control Knob to the off
position, Slide the lock handle to the
unlock position.,
t, Turn the OVEN CONTROL KNOB to the
"OFF" position,
2, Wait until the oven has cooled below the
locking temperature (approximately 45
minutes to 1 hour) before attempting to
slide the lock handle to the left into the
unlock position, When the handle slides
easily, unlock the door
1o Follow the steps under "BEi_ORE A CLEAN
CYCLE."
2, Make sure the clock iS showing the correct
time of day,
3, Turn the OVEN CONTROL KNOB to the
CLEAN position,
18
7he OVEN ONand the LOCK DOOR Indicator
Lights will blink alerting kou that the door lock
handle has not been engaged in the lock
position,
The display wlfl be showing 4.,20 and will
automatically clean for 4 hours and 20minutes
unless you should increase or decrease the
cleaning time as instructed in No, 3 under "TO
SET A CLEAN CYCLE,"
4. Sfide the doorfock handle to the right in the
lock position_ DO NOTforcethehandle If
it does not slide easi!y, it may not be fully
extended. You may also need to lightly
press against the door to lock it properly..
When the lock is engaged the OVEN ON
and the LOCK DOOR Indicator Lights wilt
glow,
5. Press the START TIME ON/OFF pad,,
6, Press the H,R UP or DOWN arrow pad to
set the hour of the day you want the cycle
to start.
Press the MIH UP or DOWN arrow pad to
set the time of the day
Once .you have set the delayed start, you may
press the OILOCK pad to return the display to
the time of day ctock When the start time you
set has been reached, the oven wit!
automatically start the clean cycle and wifl
clean for the amount of time chosen
When the clean cycle is finished, both the
OVEN ON and the LOCK DOOR Indicator
Lights will blink Turn the OVEN CONTROL
KNOB to the "OFF" position,
After the cycle .you may notice some white ash
inside the oven. Just wipe it up with a damp
cloth., If the white spots remain, scrub them
with a soap-filfed steel wool pad Be sure to
rinse thoroughly with a white vinegar and
water mixture,, These deposits are usually a
salt residue that cannot be removed by the
clean cycle, If the oven is not completely
cleaned after the cycle, the cycle may be
repeated.