Kenmore 911.9554591 Owner's Manual page 45

t. Remove the broiler pan and grid, oven
racks, utensils and any foil that may be in
the oven° ._._
2. Soil on the front
frame, 1"inside the
oven, and outside
the door gasket
will need to be
cleaned by hand.. _=,o_,-..-..
Clean these areas with hot water, soap-filled
steel wool pads or cleansers such as Soft
Scrub® to remove any soilo Rinse well with
clean water and dry..
3, Wipe up any heavy spillovers on the oven
bottom,
4. Do not clean the door gasket The
fiberglass material of the oven door gasket
cannot withstand abrasion_ It is essential
for the gasket to remain intact. If you notice
it becoming worn, frayed, or displaced on
the door, it should be replaced
The door gasket Doo.r,,_.EL GAsKet
is designed to
have a 5-6"gap
atthe bottom of
the door
This allows for no. u.E. J"
proper air circulation., It is normal for .Your oven
door to give the appearance of not having a
good seal against the range. This is due to the
gasket., The location of the gasket on the oven
door maintains a good seal and prevents any
heat loss.
CYCLE
Utensils should never be left
in a self.clean cycle.
The oven racks may be
cleaned during the self-clean
cycle, but will lose their luster
and become hard to slide. If you choose
to leave them in during the cycle, wiping
them down with vegetable oil after the
cycle will help them slide easier.
Always make sure the oven light is off
during the self.clean cycle to prolong
the fife of the bulb.
For the first clean cycle, vent the room
with an opened window or hood venL
This wil! prevent the strong odor from
heating new parts.
Clean only as touch up between clean cycles.
Use dishwashing liquid, warm water, or
soap-filled steel wool pad Rinse well after
cleaning and dry.
NEVER USE OVEN CLEANERS IN OR
AROUND ANY PART OF THE OVEN.
When cleaning, be sure not to bend or
displace the temperature sensor located on
the back wall of the oven
1 7 self-clean Cycle continued